Pneumatic accessory single ear CA

Pneumatic accessory single ear CA product details

When the load and the axis of the piston rod should be uniformly installed in the earring type and trunnion type cylinder, the swing of the cylinder and the swing of the load should be ensured in a plane otherwise, the light seal will be worn, causing air leakage and reducing the service life of the cylinder; Sometimes, the cylinder may have a striking action, which may cause damage to the human body and the device. During onsite installation of the cylinder, it is necessary to prevent the drilled chips from mixing into the cylinder foot seat cylinder from the air intake of the cylinder. If there are positioning holes in the foot seat, it can be used to locate the mounting surface of the trunnion bearing support when the distance between the mounting surface and the bearing is large. It is necessary to pay attention to the mounting surface of the mounting screw should not be too much force and damage with the fixed cylinder to make the connecting arm for circular movement, long holes can be opened on the arm, the open long holes should take into account the transverse load on the guide sleeve should not cross the specified value of the pin and other rotation should be coated with grease, in order to prevent heating so that the bonded trunnion cylinder does not break down. Due to the breakdown of the trunnion shaft and the cylinder shaft in the assembly is difficult to ensure good coordination, will lead to poor cylinder action in the piston rod end screw nut or install accessories, the piston rod must be fully retracted in order to hold the rod non-return transition cylinder, in the piston rod installation accessories, should avoid the piston rod bear rotating torque when tightening the pipe thread, the force should be suitable, Avoid damage to interface threads or air leakage

Pneumatic accessory single ear CA parameter information

Pneumatic accessory single ear CA  External specification

Pneumatic accessory single ear CA  Product Advantages

1. Integrated molding: integrated perfusion molding, not easy to break and damage；
2. Black zinc plating on the surface: not easy to rust, corrosion resistance, longer use；
3. Compact size: tight connection, good sealing, not easy to deformation。