Product Advantages
1.Compact structure:The overall height is reduced by about 50%compared to
the parallel jaw product of the same clamping force,
effectively reducing the device space and sloshing moment.
2. Double rail design:he double-track design increases the load span and the bending moment (Mr)load is better.
3. Double piston structure:Doube piston drive, double output for greater clamping force.
4. Fixed on four sides:Can be fixed in four directions and has a h igh deg ree of freedom .
5. With roundness magnetic switch slots:The roundness magnetic switch slots convenient to install DMSHICMSHIEMSH type inducting switch
6. With positioning hole:The bottom of the body is provided with a positioning hole which can improve the precision and the consistency of repeated dismounting and positioning.
product detail:
BESTEN's HFD series pneumatic fingers are a thin design with a large span and moment load capacity. Its action mode is double action type, through the double piston drive can double output, so as to obtain a larger clamping force. In addition, this pneumatic finger pays special attention to the installation accuracy and the consistency of repeated disassembly positioning, so the positioning pin hole is provided at the bottom of the body.
HFD series thin pneumatic fingers interior structure
NO | ltem | Material |
1 | Rack | Stainless steel |
2 | Jaws | Stainless steel |
3 | Guide | Stainless steel |
4 | Joint arm | Cr-Mo steel |
5 | Body | Aluminum alloy |
6 | Rack end cap | Aluminum alloy |
7 | Gear | Cr-Mo steel |
8 | Back coyer | Aluminum alloy |
9 | Baffle | Stainless steel |
10 | Front cover | Aluminum alloy |
11 | Plastic bearing | Wear resistant material |
12 | Screw | Stainless steel/Alloy stee |
13 | Screw | Alloy stee |
14 | Screw | Alloy steel |
15 | Pin | Bearing steel |
16 | Pin | Bearing steel |
17 | Piston seal | NBR |
18 | O-ring | NBR |
19 | O-ring | NBR |
20 | Magnet | Rare earth material |
21 | C clip | Spring steel |
22 | Steel ball | Stainless stee |
23 | Wear ring | Wear resistant material |
24 | Bumper | TPU |
25 | Steel ball | Bearing steel |
26 | Bolt | Alloy steel/Stainless steel |
27 | Bolt | Alloy steel/Stainless steel |
28 | O-ring | NBR |
Note:HFD8 No.12 and No.27 are made of alloy steel. |
HFD series thin pneumatic fingers external reference spec
Shipping:
Factory:
Submitted successfully
We will contact you as soon as possible