PC quick plug straight through

PC quick plug straight through How to choose the model thread size

Better understanding of PC-G straight joint, thread size/nozzle size, save shopping time, just compare the size of the original PC-G straight thread to choose the joint you need.

PC quick plug straight through  Product Advantages

1,Arbitrary rotation, flexible tube distribution: the gas pipe can also be rotated 360 degrees after installation, which can meet the needs of tube distribution in different occasions
2, Selected material, not easy to trip: the use of iron nickel plated material, rust resistance and pressure resistance, internal stainless steel spring, grasp firmly and not trip
3, Clear and strict sealing of thread: clear and deep thread, with sealing ring, free of raw material belt, strong air tightness

PC quick plug straight through caution

1, M5 thread is small, it is not suitable to use tools to tighten, because there is a gasket on it, after hand tightening
Can ensure the seal, do not screw in vigorously to prevent thread breakage. Clean pipes and joints before installation to avoid bad operation or air leakage caused by debris into the gas path.
2, too high air pressure, unclean gas will cause damage to the seal ring, it is recommended to install the air source processor in the gas path according to the actual use of the needs of the gas filter gas, choose high pressure, corrosion resistance joint.
3. During the use of the joint, do not frequently insert and remove the gas pipe, which will affect the life of the joint and gas pipe. The gas pipe must be inserted into the bottom of the connector to avoid air leakage. When pulling out the gas pipe, ensure that there is no pressure in the gas pipe, press the end cap of the connector to the bottom, and pull out the gas pipe.
4. When connecting the gas pipe, confirm whether the end face of the gas pipe is cut and smooth. The uneven end face of the gas pipe causes poor contact of the sealing ring, resulting in air leakage. You need to trim the section of the gas pipe and reinsert it into the joint to ensure that the outer diameter of the gas pipe is not damaged or cut.
5, the gas pipe should have enough length, so as to avoid excessive bending of the gas pipe at the top of the quick plug joint, causing adverse effects on the quick plug joint. After connecting the joint and gas pipe, pull the gas pipe first to check that the gas pipe is not loose, and then put into use.
6, when disassembling the gas pipe, evenly press the plastic interface, pull out the gas pipe, the press force is insufficient, the gas pipe is not easy to be pulled out, and the outer wall of the gas pipe will be cut out by the stainless steel spring causing a weak seal or air leakage. When disassembling the air pipe, do not rotate the air pipe left and right or 360°, otherwise the air pipe may be cut out of the groove and cannot be pulled out.
7, when using the throttle valve, do not use other tools other than the hand to turn the adjustment cap. When the adjustment cap is in the upper and lower limit positions, no additional external force can be applied to it, otherwise it may cause artificial damage to the joint and produce air leakage.
8, the throttle valve in the closed state allows part of the internal leakage, so it is strictly prohibited to produce internal leakage occasions Do not recommend