MAL series non-standard external spring standard cylinder

1. When the load changes during work, a cylinder with sufficient output force should be selected;

2. Under high temperature or corrosive conditions, the corresponding high temperature or corrosion resistant cylinder should be selected;

3. In the case of high humidity, dust, or water droplets, oil dust, and welding slag, the cylinder should take necessary protective measures

4. Before the cylinder is connected to the pipeline, the internal organs of the pipeline must be removed to prevent the debris from entering the cylinder;

5. The medium used in the cylinder should be filtered by the filter element of more than 40μm before it can be used

6. In the low temperature environment, anti-freezing measures should be taken to prevent the moisture in the system from freezing;

7. The cylinder should be tested for no-load operation before use, and the buffer should be adjusted to the minimum before operation, and gradually relaxed, so as to avoid excessive impact and damage to the cylinder;

8. Avoid side load, otherwise the piston rod will be bent and deformed and damage the rod end thread. The single-action type cannot be loaded when returning to the city;

9. If the cylinder is removed and not used for a long time, it is necessary to pay attention to the rust-proof surface, and the intake and exhaust ports should be added with dust-proof blocking caps, especially note: the front, rear and cover cannot be disassembled by themselves.